Mystery machine
104
messages
·
2018-05-10T19:36:02+00:00
→
2018-06-21T15:02:51+00:00
[101/104] Re: Mystery machine
2018-06-20T21:18:29+00:00
·
iron1of1
<[email protected]>
Message-ID:
<[email protected]>
Hi Kone, Sorry not to have put a number to that. But my notes are lost and memory is not very precise. I have three videos on the Zero farce motor and did not investigate the steel core addition that well. I was posting on Energetic Forum, example: Hi Yaro, As has been shown a N pole is attracted to the S end of the coil. That is with the N pole over the coil Whereas over the gap it has exactly the reverse motion, hence the bipolar switch being used However, what if we could change the magnets polarity from when it is over the coil to when it is in the gap? Easy enough to do. With the two coil setup the gap is actually too big to make efficient use of this, This is why I chose to go to six coils and six gaps of equal size. Then double up on the number of magnets. Thus when I have a N pole over the coil I have S pole over the gap. Six coils, six gaps and 12 magnets per rotor. I pulse the coil only on a N pole being over a coil. The resulting action is to pull the N pole the length of the coil and repel/attract the S pole the length of the gap, a double power stroke for each pulse if you will...plus two rotors so both sides of a coil are used... However it is a good generator and Lenz is still present so some of the claims are put in question. Ron Ron
[102/104] Re: Mystery machine
2018-06-21T01:52:57-07:00
·
Douglas Konzen
<[email protected]>
Message-ID:
<[email protected]>
Hi Ron Ok just wondering if something special about zero force motor design i will guss not although that iron tube in there is pretty interesting. I will keep with my Muller flat disc motor design as was getting 20ma at12v just one motor coil pair and it's going around 900rpm with 200mm wide rotor and 8 magnets.. My best do far about 12 years ago I got motor to go negative current with very high impedance coils and when I adjusted timing way over to one side (advanced) suddenly the meter went into negative land.. It turns slow, no torque but did see this happen. Used roller brush commutators... Seemed like the backemf/recoil/flyback became more energy combined with the power from magnet sweep in between coils pulsed... so my theory is negative sinewave peak generated by magnet sweep lines up/combines/coheres with timing of backemf/ recoil/ flyback to happen at same time going same direction. https://sites.google.com/site/alternativeworldenergy/negative-current-small-pulse-motor
[103/104] [EVGRAY] Re: Mystery machine
2018-06-21T12:48:41+02:00
·
Lutz Liebers
<[email protected]>
Message-ID:
<[email protected]>
Empty body
[104/104] Re: [EVGRAY] Re: Mystery machine
2018-06-21T15:02:51+00:00
·
iron1of1
<[email protected]>
Message-ID:
<[email protected]>
Thanks Lutz and kone for the additional information. Ron