Re: [EVGRAY] Re: Ron's Aqua Chi

Body

I am suspecting no electrolyte needed.
Otherwise it will mimic only what it comes into as an energy.



Sent from my Bell Samsung device over Canada's largest network.


-------- Original message --------
From: "Mick [email protected] [EVGRAY]" <[email protected]>
Date: 2019-06-21 12:20 PM (GMT-05:00)
To: [email protected]
Subject: Re: [EVGRAY] Re: Ron's Aqua Chi



Ron,

At least you didn't have to pay for the thing.  And a switching supply would work just fine if it had a choke, it's not noise that's the problem it the ratio of B field to E field in the electricity.  The two mixes do act differently and one can see this in sound.  For instance in preamp designs even if a switching supply is way over the amount of current necessary to present any kind of sag the thing still is missing the low end balls.

Also regulation will have different sound series like your supply, or shunt like older tube supplies.  Shunt is less efficient but in a proper design has more solid regulation on the voltage.  I have run into the same issue you have when trying to use linear supplies and not having quite the right transformer on hand then having to cheat with a huge heat sink.

Interesting you are seeing the oil though if it were me I would attempt to make changes until it produced the most of the oil, what are you using as electrolyte?

Mick

On 6/21/2019 8:40 AM, [email protected]<mailto:[email protected]> [EVGRAY] wrote:


Pardon me but I did not build a switch mode power supply, what are you babbling about???

This is a conventional old style transformer power supply with a LINEAR voltage regulator hung on it. I post this to support your work and you shoot me down?

Ron


---In [email protected]<mailto:[email protected]>, <eagleseeone@...><mailto:eagleseeone@...> wrote :

A Switch Mode Power Supply has way to much NOISE for (Bio) Field Enhancement. Its pure 'electronics'.

The Field being generated, requires Biological in origin Iron to help with the Field Generated and the Conditioning of the energy to the Array.  We do not recommend using Lead Solder in the Current flow for just this reason.
Better still would be to use Silver Electrical wire to wind the iron core of the power supply...

A switching power supply completely stops the Silver Generator from functioning. Its them 'electrons' that allows for this switching to seem ok. All that you know about 'electricity' is wrong or twisted facts.