Re: [EVGRAY] How Can the Zero-Point Energy Become an Energy Source?

Body

Kone, this washing machine deal sounds like same idea of Hectors using
brush gen head and connecting a VFD to the disconnected exciter brushes
then tuning the VFD pulse to the sweet spot for the motor speed at the
load required.  The VFD likely works better or only owrks if the system
is also servoed so the VFD is synched to pulse from one shaft position
so phase is always as needed.  Without the servo I think the system
would have too mush drift even if one was lucky enough to get it spot on.

On 11/13/2018 9:18 PM, [email protected] [EVGRAY] wrote:
>  
>
> Hi James
> I wrote Gary a few days ago have not heard back last video he put up
> his speed and pulse controller blew up from stray wire and is fixing it.
> In nutshell what I know he uses one of those pancake washing machine
> motors with perm magnet rotor on out side of stators....he puts his
> own hall effects on it and spins it then with toothed rubber
> automotive timing belt and pulleys he spins pancake motor say 500rpm
> (guessing) while two stepper motors Working as generators hit their
> sweet spot in rpms where they get delayed Lenz effect and speed up
> under loading and trick is to find tis rpm window and step up to
> perhaps 4000rpm [guessing)) and find that narrow rpm window they must
> spin at to negate Lenz law...might be window.of only 200rpm to
> find...so under 3900 and over 4100 will not work as example and guess.
> Gary said the guy told him to test unit under load, run it up and down
> in rpms until you find where amp draw goes down dramatically to
> pancake motor the that should be sweet spot to run it at.
> Gary also said it looped without a flywheel but it helps a lot when
> introducing the load to generators to prevent stalling.
> Look on YouTube "Don Smith #187 "
> Kone
>
>