Re: [EVGRAY] Re: Panacea site

Body

https://en.wikipedia.org/wiki/Synchronous_condenser


On 11/3/2018 2:18 PM, Mick [email protected] [EVGRAY] wrote:
>
> Dave,
>
> By setting up a rotary condenser one can make the analog meters run 
> backwards.   Not sure how the new smart meters process a leading phase 
> angle but doubt they can be manipulated this way.
>
>
> On 11/3/2018 8:13 AM, Dave Muckerman [email protected] [EVGRAY] wrote:
>> Yes, I found that Rotov. adds or subtracts magnetic and physical 
>> momentum if you have just the right motor.
>> I made 10HP Emerson "boat anchor" that didn't work when I found each 
>> pole and counter pole winding was 2 wires together in 
>> parallel(bi-filler, not tesla), and this 240/480V, 4 pole (3.6KRPM) 
>> motor used bifiller windings.
>> So it actually has 48 wires bonded together.
>> I needed to tear all 24 bi-filer ends aprt. to connect them end to 
>> end or series to increase the impedance so now it can start and run 
>> on less power by magnitudes.
>>
>> Another thing one can do by poking through the wire enamel with sharp 
>> ohm-meter probe to find half the DC res. of each pole and 
>> counter-pole, the middle of each wind, and experimenting with this 
>> center-tap.
>>
>> Now think of how a utillity/hydro KWH meter magnetic motor can run 
>> backwards when the magnetic field lag between two or more poles are 
>> reversed.
>>
>>
>> On Saturday, November 3, 2018 6:42 AM, "[email protected] 
>> [EVGRAY]" <[email protected]> wrote:
>>
>>
>> Maybe its more "if you are a bitch at it" its impossible to tune !!! 
>> LOL !
>>
>>
>>
>>
>>
>>
>> ---In [email protected], <laser.rod@...> wrote :
>>
>> H,
>> Like you always say"it's a bitch to tune" right?
>>
>>
>> On Friday, November 2, 2018 8:40 PM, "arkresearch@... [EVGRAY]" 
>> <[email protected]> wrote:
>>
>>
>> He gave up on doing the correct thing ....as there is only one way to 
>> do this mission ...
>>
>>
>>
>>
>> ---In [email protected], <laser.rod@...> wrote :
>>
>> Old news.
>> Ash's site I think.
>> He gave up on the rotoverter and does not post here anymore..
>>
>>
>>
>>
>
>