Body
well you can get a $7,000 fine by the power company ....
---In [email protected], <mkjekyll@...> wrote :
Dave,
By setting up a rotary condenser one can make the analog meters run backwards. Not sure how the new smart meters process a leading phase angle but doubt they can be manipulated this way.
On 11/3/2018 8:13 AM, Dave Muckerman laser.rod@... mailto:laser.rod@... [EVGRAY] wrote:
Yes, I found that Rotov. adds or subtracts magnetic and physical momentum if you have just the right motor.
I made 10HP Emerson "boat anchor" that didn't work when I found each pole and counter pole winding was 2 wires together in parallel(bi-filler, not tesla), and this 240/480V, 4 pole (3.6KRPM) motor used bifiller windings.
So it actually has 48 wires bonded together.
I needed to tear all 24 bi-filer ends aprt. to connect them end to end or series to increase the impedance so now it can start and run on less power by magnitudes.
Another thing one can do by poking through the wire enamel with sharp ohm-meter probe to find half the DC res. of each pole and counter-pole, the middle of each wind, and experimenting with this center-tap.
Now think of how a utillity/hydro KWH meter magnetic motor can run backwards when the magnetic field lag between two or more poles are reversed.
On Saturday, November 3, 2018 6:42 AM, "arkresearch@... [EVGRAY]" mailto:arkresearch@...[EVGRAY] <[email protected]> mailto:[email protected] wrote:
Maybe its more "if you are a bitch at it" its impossible to tune !!! LOL !
---In [email protected] mailto:[email protected], <laser.rod@...> mailto:laser.rod@... wrote :
H,
Like you always say"it's a bitch to tune" right?
On Friday, November 2, 2018 8:40 PM, "arkresearch@... [EVGRAY]" mailto:arkresearch@...[EVGRAY] <[email protected]> mailto:[email protected] wrote:
He gave up on doing the correct thing ....as there is only one way to do this mission ...
---In [email protected] mailto:[email protected], <laser.rod@...> mailto:laser.rod@... wrote :
Old news.
Ash's site I think.
He gave up on the rotoverter and does not post here anymore..