Body
Jacob! That would be a rather complex answer but here is your starting
point!
https://kundoc.com/pdf-direct-thermomagnetic-splitting-of-water-.html
After having been heavily involved in the COLD FUSION Research back in
the 70s and 80s I quickly settled o0n the best catalyst in electrolytic
cells which is pure nickel. I still have the cell used in the Elemental
Replication experiments.
http://www.rexresearch.com/gunnrman/gunnrman.htm The hidden part of
this research is the use of a nickel component in the combustion
chamber. Bosch developed 90,000V ignition systems to enable water
injection in gas engine which high lighted the Graneau HV decomposition
of water via HVDC discharge!
My magnetic Battery when run as an electrolytic cell to produce hydrogen
does produce a huge amount of hydrogen gas as shown by the Dr. Ehrenhaft
document. I would tell you to pursue the super high Tesla magnetic flux
and nickel electrodes in an electrolytic cell. The major obstacle to be
overcome is the rapid collection of ions from solution by the 1.3 Tesla
flux across a .020" mechanical gap which quickly takes the cell into a
super-conduction mode which takes out the driving DC power supply. You
can flush the magnetic gaps with distilled water and the gaps will show
in the meg-ohm range then go to zero ohms after a short period of
running, the gathered ions totally short cell. During the brief runs
there is a huge amount of hydrogen gas produced which I burned off as it
was generated. Much can be said about driving the cell with high
frequencies as the Myers research showed. Our friend up in Canada at
George Wiseman, Eagle Research is running well ahead of the crowd on the
production of H-H-O.
Just for giggles!
16 October 1996
*To: Hal Fox,Fusion Facts*
*Elemental Replication ?*
**
Around mid September I put together an electrolysis cell similar to the
Miles Nickel Cold Fusion Cell with the goal of exploring the
possibilities of making what is termed “Pristine Water”.This water which
will be used by Homeopaths will have had all memory or information
removed.This is accomplished by recombining monatomic hydrogen and
monatomic oxygen as generated in a properly designed cell.This is the
ultimate in purity since this is water with conditions at the time of
original creation.“Holly Water”is a term coined by my dear friend and
fellow researcher Joe Tyls of Vancouver, BC.After several weeks of
successful operation producing water that had all the earmarks of a true
“pristine water” a fellow researcher suggested using an alternate
electrolyte.A solution was selected that contained 77 colloidal minerals
as found in plants that are the easiest assimilated into the body.With
the electrolyte changed the cell was put back into operation as before
with a nice recombination burn and production of the sought after
“pristine water”.
After about an hour of operation the cell went absolutely “nuts” with
the temperature rapidly climbing to boiling point and the current out of
sight.When the cell was opened we found a deep red sludge deposit which
shorted the cell plates.Our first thought was that the electrolytic
action precipitated out the colloidal minerals which caused the deposit
found.Theelectrolyte was allowed to settle out the
precipitate.Afterdecanting off,the clear electrolyte was returned to the
cell for another run. Again the cell operated normally for about an hour
with a normal recombination burn and recovery of the water being
consumed by the cell in the splitting action.Again the cell temperature
and current mirrored the first run.Again the cell contained the same
amount of sludge residue.This process was repeated ten (10) times with
exactly the same results.All of the sludge was carefully dried and
weighed on an electronic scale with a five decimal resolution.The cell
plates and all hardware were weighed to determine any loss of mass that
may contribute to the mass gain observed in the sludge.Five hundred
(500) ml of the original electrolyte solution used in the cell was
vacuum distilled to determine the exact mass of colloidal minerals
contained.When all factors were considered we came out with a mass gain
of48 gm which cannot be explained by conventional electrolysis.
After talking to Dr. Robert Bass and Hal Fox I learned of a patent that
has been filed on the transmutation of elements in the cold fusion cell
which is the process that Dr. John Bockris has been so active in.Both
Dr. Bass and Hal Fox stated that what I was observing is not the same as
the transmutation observed in the cold fusion cell since I have a
overall mass gain and not a lateral movement of elements in the periodic
table toward lighter elements with a resulting heat release.This unusual
cell operation has caused quite a reaction in the scientific community.
At this time I have built a complete new cell with every possible factor
which could possibly explain the mass gain considered and documented.The
ten (10) consecutive runs on the new cell will be completed soon and a
report will be forthcoming.What is interesting about this phenomenon is
that when an eleventh run was made with the original electrolyte exactly
the same amount of residue was recovered as in the previous ten runs.
Since the same electrolyte is reused each time with only distilled water
being added to replace the volume lost by the removal of the solids and
the water recovered by the recombination burn we are hard pressed to
explain the observed phenomenon.The electrolyte appears stronger in
mineral concentration and shows no sign of depletion.
After conferring with Joe Tyls we arrived at the conclusion that the 77
colloidal minerals contained in the electrolyte provide the atomic
templates needed for the monatomic hydrogen (father of all the elements)
to replicate selected elements in this exotic mixture.If you subscribe
to the theories of the late Walter Russell and his explanation of the
octave based periodic table with monatonic hydrogen being what he
describes as hydrons (precursor to hydrogen) then it is possible for the
replication of elements directly from energy input alone.This is how all
matter was created in the beginning as described by Schappeller in “The
Physics of the Primary State of Matter”.I will keep all informed as to
our progress and findings in this very intriguing venture.
Norman Wootan
P.O. Box 141049
Dallas, TX 75214
(214) 360-0865
CC:Gene Mallove, Infinite Energy
CC:Dr. John Bockris, Texas A/M
On 10/28/2018 1:01 AM, Jakob Wall [email protected] [EVGRAY] wrote:
>
> Thanks Norman,
>
> BTW, what is the most effective water split device that you ever put
> you hands on?
> As HHO researcher for dekades you should be able to point us directly
> to the most effective known!
> Please be specific about reconstruction of the same, since we are in
> public domain it will become public knowledge and public good. I
> assume you intend nothing else,rigth ?
> --------------------------------------------
> On Sat, 10/27/18, Norman Wootan [email protected] [EVGRAY]
> <[email protected]> wrote:
>
> Subject: Re: Fwd: Fwd: Re: [EVGRAY] Norm's Magnetic Battery [3
> Attachments]
> To: "Bert Pool" <[email protected]>, "Bob Paddock"
> <[email protected]>, "joel mcclain" <[email protected]>, "Jon
> Gentry" <[email protected]>, "Lane Wootan" <[email protected]>,
> "Mbking42" <[email protected]>, "Toby Grotz"
> <[email protected]>, "Phil Rembold" <[email protected]>,
> "Angel Alvarez" <[email protected]>, "Fredric Fletcher"
> <[email protected]>, [email protected]
> To understand the unwinding of a thread leading
> to Magnetic
> Generating Hydrogen and this Magnetic Battery, we have
> to dust off
> our 9th grade Chemistry Books!
> http://www.rexresearch.com/ehrenhaf/ehrenhaf.htm
> I guess Dr.
> Ehrenhaft was the first to propose a Magnetic Current.
> (Jon
> Gentry, Your liquid metal vortex helix).
> https://revolution-green.com/can-electrolysis-powered-magnets/
> Ah! Ha! more on Magnetic Currents!!!
> https://sciencing.com/magnetic-properties-hydrogen-7648446.html
> https://www.labmanager.com/white-papers-and-application-notes/2010/05/resistivity-conductivity-measurement-of-purified-water#.W9So9uJRc2w
> https://www.askiitians.com/forums/Physical-Chemistry/19/19074/electro-che
> https://en.m.wikipedia.org/wiki/Overpotential
> https://www.quora.com/Why-is-oxygen-molecule-paramagnetic-although-it-does-not-contain-any-unpaired-electron
> https://www.researchgate.net/publication/251580541_The_effect_of_magnetic_force_on_hydrogen_production_efficiency_in_water_electrolysis
> http://www.physicscentral.com/experiment/physicsathome/electricwhirlpool.cfm
> http://www.linux-host.org/energy/bmagpump.htm
> Now Jon Gentry you have your liquid metal pump so
> that you can
> make the helix tube Vortex! Ferricpetacarbonyl or
> micro fine neo
> powder to provide the liquid metal for pump
> circuit.
> Lots of reading here! Please think about the
> ramifications of
> a Magnetic Current as proposed by Dr. Ehrenhaft!
>
>