Re: [EVGRAY] Cap charging and use

Body

Warren,

Use what ya got.

Ok number one I would take that transformer and use a sine wave
generator to find the resonant points of each phase.  Map each coil
L1-L3 on paper based on the three highest gain frequencies you can find
and check their harmonics and write down the voltage differential
between the root and the 1/2 and 1/4 and 1/3 and 1/6

https://www.youtube.com/watch?v=egDmVZ3FXP4


On 10/9/2018 8:27 AM, Warren Keillor [email protected]
[EVGRAY] wrote:
>  
>
> Mick
>
> What you are saying makes sense, but, as always, the devil is in the
> details.
> I have all sorts of motors, both DC and AC,( becoming one of those
> crazy old hoarders, one reads about) in my collection.
> I think I might need help in thinking this through, and choosing the
> best possibility of success.
> My transformer is a Varian, made for high tech scientific, military
> satellite down station installation, likely from the mid seventies, or
> early eighties. No info available on it, or any of the equipment. It
> is three phase, with very fat wire of a rectangular cross section
> There are air gaps between various windings in each coil, with
> considered spacers separating these coils from each other, wrapped
> around each leg of the three core legs, as they wind one layer on top
> of another.
> Does that make sense to you?
> Cheers Warren
> Sent from Yahoo Mail on Android
> <https://go.onelink.me/107872968?pid=InProduct&c=Global_Internal_YGrowth_AndroidEmailSig__AndroidUsers&af_wl=ym&af_sub1=Internal&af_sub2=Global_YGrowth&af_sub3=EmailSignature>
>
>     On Tue, 9 Oct 2018 at 5:46 AM, Mick [email protected] [EVGRAY]
>     <[email protected]> wrote:
>      
>
>     Hi Warren,
>
>     I am taking baby steps in order to get the wheat from the chaff. 
>     As far
>     as I am aware the Smith device is like the electronic lever of
>     Archimedes in which at high enough voltage there is a bifurcation
>     point
>     in order to tap earth power acting as a mirror boundary wave or rather
>     an emp.  Much work is required and there is much more to the
>     design than
>     any of the so called experts have disclosed as coaxing the response is
>     tricky and then controlling the type of energy produced is a challenge
>     to electronic component welfare.  He was jacking up the voltage
>     and then
>     utilizing several ways to gain voltage advantage and B field
>     modulation
>     prior to stepping down for the high current lower voltages.  So in
>     other
>     words the gains made at high voltage low current are leveraged during
>     the step down.
>
>     If you intend to go the transverter route, this looks much easier to
>     meet expectations. My suggestion would be to utilize a synchronous
>     condenser.  If one looks at the Kapanadze devices in the high power
>     system at the power plant and also on the island one will notice a
>     motor
>     running without a load.  I suggest this is a motor/generator
>     functioning
>     as a rotary condenser in order to change the RF reactive KVAR into
>     watts.  In order to transform large amounts of energy this is a cost
>     effective solution other than many caps for storage.   The transverter
>     can be run as close to pure reactive as possible and then convert over
>     to useful power corrected tuned to match your load.  I think this is a
>     much quicker solution as the earth energy harvest still has some
>     serious
>     sorting out requirements.
>
>     Norm has recently posted concerning that condenser and capacitor are
>     independent definitions, hint hint... so my advice to you is look
>     up and
>     learn all your can concerning synchronous rotary condensers!  Then use
>     your RV to power correct the TV.
>
>     Hope this makes sense!
>
>     On 10/9/2018 1:19 AM, Warren Keillor [email protected]
>     [EVGRAY] wrote:
>     > 100mf 4000
>
>