Re: [EVGRAY] charging caps

Body

Mick
If you now make a pancake coil identical to the secondary but reverse the
winding direction according to don your amps will go up but connect the
ground at the common junction between the two and pull from the other two
ends .should increase Watts .according to Don's system .
On Oct 9, 2018 2:14 AM, "Mick [email protected] [EVGRAY]" <
[email protected]> wrote:

>
>
> My little experiment charging caps from pancake coils.  A couple
> interesting developments:
>
> 1  Don Smith was right, the cable thickness provides more potential
> current.  Using the zip cord pancake L2 as a pickup above the induction
> cooker coil L1.  This is a 15 foot coil which can be connected in
> bi-filar or normal pancake or double normal pancake.  Even with a very
> low current circuit using both sides of the zip cord charges caps much
> faster than a single side and the single pancake faster than the
> bi-filar which is higher voltage but lower current.  would be a good
> idea to try with a bifilar the same length as the single pancake.  I
> realize this is a simple assumption as the pair of cables could have a
> lower ESR and capacitive reactance rather than the single terminal, so
> more experiments are in order.
>
> 2.  Connecting a single ground wire in the proper place in the circuit
> provided a voltage gain from 450 to 506v, have a feeling when voltage
> gets much higher so will the gain.  Noticed the longitudinal signature
> almost by accident as a small loop of magnet wire connected to an LED,
> the LED gave a faint glow when I connected th.e earth to the proper place.
>
> Using DC so position of the coils is important, fastest charging appears
> when positive is shot into the center to the outside and diode in L2 is
> same polarity and center to outside.
>
> Anyone working on Smith devices I suggest one uses a LED with a loop to
> indicate when the magnetic wave is available.
>
> 
>