Re: [EVGRAY] Cap charging and use

Body

Hi Warren,

I am taking baby steps in order to get the wheat from the chaff.  As far
as I am aware the Smith device is like the electronic lever of
Archimedes in which at high enough voltage there is a bifurcation point
in order to tap earth power acting as a mirror boundary wave or rather
an emp.  Much work is required and there is much more to the design than
any of the so called experts have disclosed as coaxing the response is
tricky and then controlling the type of energy produced is a challenge
to electronic component welfare.  He was jacking up the voltage and then
utilizing several ways to gain voltage advantage and B field modulation
prior to stepping down for the high current lower voltages.  So in other
words the gains made at high voltage low current are leveraged during
the step down.

If you intend to go the transverter route, this looks much easier to
meet expectations. My suggestion would be to utilize a synchronous
condenser.  If one looks at the Kapanadze devices in the high power
system at the power plant and also on the island one will notice a motor
running without a load.  I suggest this is a motor/generator functioning
as a rotary condenser in order to change the RF reactive KVAR into
watts.  In order to transform large amounts of energy this is a cost
effective solution other than many caps for storage.   The transverter
can be run as close to pure reactive as possible and then convert over
to useful power corrected tuned to match your load.  I think this is a
much quicker solution as the earth energy harvest still has some serious
sorting out requirements.

Norm has recently posted concerning that condenser and capacitor are
independent definitions, hint hint... so my advice to you is look up and
learn all your can concerning synchronous rotary condensers!  Then use
your RV to power correct the TV.

Hope this makes sense!


On 10/9/2018 1:19 AM, Warren Keillor [email protected]
[EVGRAY] wrote:
> 100mf 4000