Re: [EVGRAY] Bifilar Coil for Electromagnets

Body

Norm, You may find this interesting

https://www.youtube.com/watch?v=sXKJjNAZDEM


On 8/27/2018 7:06 AM, Norman Wootan [email protected] [EVGRAY] wrote:
>  
>
> Hello all!    Since the subject of bifillar coils has surfaced again,
> Let me share a little experiment that was spurred by Tom Bearden when
> he published his Phase Conjugation ideas!  Out of curiosity, I wound a
> long solenoid air core coil with two strand 18 ga. stranded zip
> wire.   I was careful to wind the turns flat ,single layer tightly
> wound so that mutual induction between turns phase cancelled the
> vectors of the electric fields and the magnetic fields. what bifiliar
> should do.  I used a Ramer Impedance Bridge to get my winding to the 8
> Ohm impedance needed for my 100 watt/channel stereo amplifier when fed
> by a pure sine wave of 400Hz signal.  (Note: I did not attempt to find
> a resonant point for the coil) The hook up is simple and You can watch
> on a scope the stereo amp output Channel A & B being exactly 180
> degrees out of phase into the air core 8 Ohm / winding.  When brought
> up to 100 watt power dissipation / channel into the 8 Ohm impedance
> there was no detectable fields either electric nor magnetic fields
> although the power meters showed a total of 200 watts of energy being
> consumed.  What is your opinion as to the form that the power was
> converted into?? Yes there was associated heat generated in the air
> core windings.  When phase cancellation removes the vectors from the
> equation, does the energy become Longitudinal wave without any
> detectable fields???
>
> https://www.diffen.com/difference/Electric_Field_vs_Magnetic_Field
>
> On 8/27/2018 6:17 AM, [email protected] [EVGRAY] wrote:
>>  
>>
>> Hi Kone,
>>
>> The energy has to be input as two separate parts and then mixed into
>> a coherent single part to be extracted for driving the load. Look at
>> how Pierre Cotnoir did it. His device didn't require resonance which
>> makes it drive different loads without having to readjust everything.
>> He has overcome the tuning bitch. I'll try something like that. But
>> the progress is going very slow. This far two MOSFET hex bridges are
>> completed and working.
>>
>> Mixing energy is not just mixing voltage or mixing current as both of
>> those parts as well as time (actually change) are parts of energy.
>> Think of energy and not just the parts making up energy. Energy comes
>> in quite many types. It's the output energy that has to be greater
>> than the input energy to be able to extract free energy. The excess
>> free energy is then extracted out of the cosmic background or aether
>> of electrons (or positrons).
>>
>> Regards
>> Ole
>>
>>
>>
>> ---In [email protected], <konehead@...> wrote :
>>
>> Hi James
>> Perhaps "bifilar backemf" (the inductive kickback spikes from a
>> bifilar coil)
>> Is of greater power when first you split then combine the inductive
>> kickback spikes produced.
>> This means bifilar half A is fed the.pulsed DC power (or alternating
>> polarity pulsed DC for AC)
>> And steering diodes capture the kickback spike into cap (s).
>> Then the other half (B) of bifilar is not driven by direct power feed
>> but rather is only induced by bifilar half A.
>> Now either combine kickback spikes from each into common cap or fill
>> up separate caps for each bifilar half.
>> Could be creating a "coherence" condition as Ole speaks about, from W
>> B Smith writings.
>> The capacitors filled need to be disconnected from the coil whenever
>> they discharge to load for real power to be seen with no reflection
>> back to primary input.
>> Kone
>
>