Re: [EVGRAY] Re: Spark gap

Body

Warren I was thinking of using old batteries not usable for anything but
recycling .the plastic Case's too . what do the use for a bus bar to
connect the plates .?
On Aug 2, 2018 10:03 PM, "Warren Keillor [email protected]
[EVGRAY]" <[email protected]> wrote:

>
>
> James
> It is not so difficult to make your own battery plates of the deep cycle
> type.
> First of all deep cycle batteries have plates that can be 1/4" thick!
> You can easily pour 1/4" plates on a thick steel plate laid down
> absolutely level with 1/4" sides.
> For smaller lead sheets, I melt them in a seamless tin can.
> For the really large plates I use a large electric crucible.
> They need a plastic tank.
> Cheers Warren
>
> Sent from Yahoo Mail on Android
> <https://go.onelink.me/107872968?pid=InProduct&c=Global_Internal_YGrowth_AndroidEmailSig__AndroidUsers&af_wl=ym&af_sub1=Internal&af_sub2=Global_YGrowth&af_sub3=EmailSignature>
>
> On Thu, 2 Aug 2018 at 6:22 PM, James Glinski [email protected] [EVGRAY]
> <[email protected]> wrote:
>
>
> Warren would be so kind as to relate the information on construction of
> the DIY deep cycle batteries your German friend told you ?you said I think
> something about iron and casting .I think that DIY deep cycle batteries
> would be a good combo with Rene or Bedini charging .thanks for your time
> Jim .
>
> On Wednesday, August 1, 2018, Warren Keillor [email protected]
> [EVGRAY] <[email protected]> wrote:
>
>
>
> Sven
> Do I understand you correctly that you use a single diode in the old Tv
> transformer circuit to rectify to a dc spark, rather than a full wave diode
> bridge?
> Is it OK to use a fwd circuit, and still get the efficiency you are seeing?
> Cheers Warren
>
> Sent from Yahoo Mail on Android
> <https://go.onelink.me/107872968?pid=InProduct&c=Global_Internal_YGrowth_AndroidEmailSig__AndroidUsers&af_wl=ym&af_sub1=Internal&af_sub2=Global_YGrowth&af_sub3=EmailSignature>
>
> On Wed, 1 Aug 2018 at 3:01 PM, [email protected] [EVGRAY]
> <[email protected]> wrote:
>
>
> Hello Jakob, you quoted me.
>
> The way I see your drawing I should use the energy to pass it through a
> transformer before. The spark is quite small and if you touch your
> fingers there is a tingling, I do not think that you can draw the power
> from it.
>
> On my Youtube channel, I have a better experiment on the connection of the
> earth.
>
> It's about a diode splitter transformer from an old TV with which I
> generate high voltage and discharge the energy over a spark gap.
>
> When I connect the earth to the negative side minus the spark gap arcing
> increases sharply to the number in the same time, without the extra energy
> being applied.
>
> I find that very interesting that over the earth apparently extra energy
> is sucked in.
>
> Personally, I find it very dangerous to work with these voltages, and
> spark gaps are not my cup of tea since it produces ozone and is not exactly
> health promoting. laughing.
>
> regards
>
> Sven
>
> 
>