Re: [EVGRAY] Re: Freon drive power unit

Body

Just using butane is good with a solar pond of salt water you can run at
night like that .and direct from solar copper tubing in the day. A double
action steam engine works well .I forgot the name right now but was
recommended by a engineer retired it would work better if your near water
for cooling . you might use ionic wind for cooling .good luck
On Jun 21, 2018 10:26 PM, "Mike Rady [email protected] [EVGRAY]" <
[email protected]> wrote:

>
>
> I am trying to build power unit that runs off of heat like the
> refrigerator in some campers I have a large wood burning heater that heats
> my water for radiant tubing and my shower water it has a very thick wall
> pipe running through it to heat the Freon then a metering valve. I should
> mention it has a one way valve before it goes in to the heater. It will
> heat the Freon creating a lot of pressure it then goes through the metering
> valve for regulating the drive motor. From drive motor to oil separator to
> expansion chamber to cool it down then out through copper tubing running
> through the back yard. Then back to heater. It will have a bypass valve and
> pop off valves for safety
> The part I’m not sure about is how I should build the expansion chamber I
> will want to run at least two evaporates for some cool in the house but
> that is an after though The main thing is it runs a generator. To clarify.
> A little more my drive motor is a power steering pump off of a Peterbilt I
> used to have. An air starter might be better but most of those you can’t
> plumb out of they just bleed their air off to the atmosphere. I push about
> 30 psi. Through this power steering pump at the pressure port it was strong
> enough to wear good little hole in my tennis shoe when I tried to hold it
> down. Any thoughts or comments would be welcome best regards mike
> Sent from my iPhone
> 
>