Flux circuit

Body

Kone,
 

 Experimenting with electromagnets in order to examine a perpetual motion holder I came upon an interesting result.
 First after the inital pulse to hold the two pieces together the wiring can be disconnected and no longer seems to matter.
 However the units will not stay stuck if the magnetic cores are seperated by the tiniest gap of something non ferro like paper or aluminum foil.
 

 This seemed rather facinating that the naked magnets energized would stick together until pulled apart then not stick again without repeated power but if any non ferro "insulator" was put between the two then they would only stick with power on.  The cores are mumetal so not apt to stay magnetized.
 

 I was wondering if you exloited this condition in any of your konemotors?  Often the tiniest of flux will destroy the FE performance such as in a Joe Cell or TPU.
 

 Hector mentioned he was able to get an Eklinator working by removing the flux shorted parts of the device.
 

 Thinking along these lines back to Hector and his paper gapped tranny(transformers not chicks with dicks) laminations.  When one desires the fast n' easy magnetic switching along the lines of VTA or MEG then perhaps engineering around the perpetual motion holder effect is advised.
 Sometimes the flo of fast n' easy is so niiiice.