Re: [EVGRAY] Dotto Ring

Body

Yes! It worked to my satisfaction!  I had a piece of DC buss bar copper 
(99.9 copper), 36 " long X 3 " wide X 1/2 " thick that I heated and 
"dead soft" annealed to get a  four decimal place .0000 on a DVM.  
Formed the 12 " circle coil with a two inch opening between the ends. 
After forming the circle, had to re-anneal to remove any work hardening 
from the forming process!  (Very important).  Heated  one end with a 
Bunsen burner and cooled the other end with  some liquid CO2 and got 
about 50 milivolts on the DVM across the ends.  The bar resistivity was 
probably  around .ooo1 ohms Ohm's Law said there was about 500 amps 
flowing cause a good magnetic field was generated.   Satisfied me that 
the "Thermonic principle worked!   I had a lot of real neat RF Tank 
coils wound with 3/8" copper tubing that I got from Varian Corp. Dallas 
and the old Continental Corp, Dallas and asked Engineers about how they 
were made.  Same annealing process to lower resistance to lowest 
possible value then they were "silver plated"!  Hector has seen a 
"million" of them!  Lol


On 3/22/2018 3:02 PM, James Glinski [email protected] [EVGRAY] wrote:
>
> You built it ....well did it work ??
>
> On Mar 22, 2018 10:16 AM, "Norman Wootan [email protected] 
> <mailto:[email protected]> [EVGRAY]" <[email protected] 
> <mailto:[email protected]>> wrote:
>
>     http://orgoneproducts.org/blog/2008/03/10/dotto-ring-heavy-gravity-machine/
>     <http://orgoneproducts.org/blog/2008/03/10/dotto-ring-heavy-gravity-machine/>
>
>
>     Sent from Yahoo Mail on Android
>     <https://overview.mail.yahoo.com/mobile/?.src=Android>
>
>