Re: [EVGRAY] Re: buck plug ...

Body

Hello Ole, Warren, Douglas and all,

Yesterday I experimented again with the Tranverter and found that you can watch the diode plug well synonymous of the input sine on the coupling capacitors on the diode connector page well.

The thyristors discharge very fast because there is nothing to improve even with 500 watts of load purely resistive load as a light bulb.

But you can modulate the signal from there as a sine well with the adjustable ignition of the thyristors. So that one receives short empty steps and lo and behold the input power decreases despite full luminosity at the output.

I wonder, can you load these spikes of the Pushpull transformer via a FWBR directly into a battery?

I tried to connect a 2 transformer in parallel but the impedance is so high despite a short circuited secondary that the thyristors can not turn off.

Then I switched 2 of the transformers on the primary side in parallel, then it just happened. It's pretty hard to work that way, it would be nicer if you can shut down the SCR appropriately, but they are almost indestructible to an IGBT or Mosfet. I also do not think that an IGBT can stand the high current increase unless it is pulsing fast.

What about Hector, is he swallowed up from the ground?
I feel that general topics are being relayed and project related information is not arriving. Somehow I have the feeling there is already method behind it.

regards

Sven