Body
Warden don't stand still you might get boxed !.I was wondering what the
out put of your cascading DC motors would be if you put pulley's on them
and connected to a small Muller generator ? Or a no Liz gen if one could be
found ?
On Dec 15, 2017 13:29, "Warren Keillor [email protected]
[EVGRAY]" <[email protected]> wrote:
>
>
> Sven
> I too, don't understand how it works.
> There is no doubt, however, that it worked for me.
> Lucky for us, I found most of the motor setup still intact, but it is
> enroute to my new home, and studio, in any of several hundred cardboard
> shipping boxes, contained in three big trucks.
> I am just cleaning up the debris here.
> The vacuum cleaner is gone.
> The old boom box radio is gone.
> I dropped one glove out of my pocket yesterday. It was packed before I
> could pick it up.
> In spite of my most vigilant efforts, there is no organization to any of
> the stuff.
> A whole big box of scrap metal and
> utter junk, was wrapped in brown paper, and packed too.
> The three guys lifted and pushed up a ramp to a truck, my Brown & Boggs
> half a ton sheet metal shear made of heavy cast iron. I couldn't do that,
> nor would I attempt it.
> They seemed to take enormous pride in their feats of strength, and vigor
> at working.
> Cheers Warren
> Sent from Yahoo Mail on Android
> <https://overview.mail.yahoo.com/mobile/?.src=Android>
>
> On Fri, Dec 15, 2017 at 11:31 AM, 'S.friedrich' [email protected]
> [EVGRAY]
> <[email protected]> wrote:
> Hello Warren, the sketch is artistically very beautiful but tells me the
> same thing as circuit Ole has posted. If you send Dc through a Fwbr dc
> comes out again. So you drive all engines with the first energy of the
> first engine. As I have drawn the 2 engine would be operated with the
> flybacks of the first and so on. I can not understand the meaning of Fwbr.
> Sorry greetings Sven
>
>
> Von Samsung Mobile gesendet
>
>
> -------- Ursprüngliche Nachricht --------
> Von: "Warren Keillor [email protected] [EVGRAY]"
> Datum:15.12.2017 14:39 (GMT+01:00)
> An: EVGRAY YahooGroups
> Betreff: [EVGRAY] Quick sketch
>
>
>
>
>
> Sven
> This is not a schematic
> I borrowed a pen and paper to try to show how the components look and are
> hooked up.
> 12v battery, 120 volt 60hz inverter, 5 amp Variac, 120 volt AC in, set to
> 35 volts out, simply because some of the motors were marked 40 volts. With
> these DC motors, this means nothing except the rpm range that that motor
> runs at in the application it is being used for.
> Using them as high torque servos running at slow speed, just use bigger
> motors at lower voltages. It seems, from my wing generator experience, that
> they just make general use motors, and you supply the voltage it needs to
> run for your application. Most of my motors came with optical readers on
> one end of the shaft, which I did not use, as normally I just needed stupid
> generators making DC amperage from the wind.
> I hope my sketch is of some help.
> Cheers Warren
> ,
>
> Sent from Yahoo Mail on Android
> <https://overview.mail.yahoo.com/mobile/?.src=Android>
>
>
>