Re: [EVGRAY] Energy harvesting Weigand
4
messages
·
2018-09-08T21:28:54-04:00
→
2018-09-10T12:24:29+00:00
← Previous
Page 1 of 1
Next →
[1/4] Re: [EVGRAY] Energy harvesting Weigand
2018-09-08T21:28:54-04:00
·
einspace2005
<[email protected]>
Message-ID:
<CAMcJfsMEHmAdfzNcghcZEbqp-Piq7VKX-qc-pS=XQdrMeHczkA@mail.gmail.com>
Will keep paying attention on your progress. Thanks. einspace
[2/4] Re: [EVGRAY] Energy harvesting Weigand
2018-09-09T16:10:05+00:00
·
james glinski
<[email protected]>
Message-ID:
<CA+uJ=ncEgtYccajiVHUzSuhodb+zdEZvmgPXa5LzAE=-3LoCAA@mail.gmail.com>
Thanks silver that was a pretty good answer rich in coverage . I have felt if we could replicate teslas discovery simply as he described were it charges everything in the room and down stairs as well .we will have it down to its simplest form and can go from there .anywhere. The base conditions . that would show the similarly with don smith's work and bedini's as of shoots of Tesla in a easily relocatable form . thanks again . jim On Sep 8, 2018 8:29 PM, "Jonathan Rivera [email protected] [EVGRAY]" < [email protected]> wrote: > > > Will keep paying attention on your progress. Thanks. > > einspace > >
[3/4] Re: [EVGRAY] Energy harvesting Weigand
2018-09-09T17:00:22+00:00
·
silverhealtheu
<[email protected]>
Message-ID:
<[email protected]>
Tesla if you study his patents is not just about high voltage streamers. Many of his patents show a TX and RX then a mechanical commutator timing system linking the two components together then powering dozens of lamps and large AC motors. He was very aware that unless you use a synchronized burst all you have to show for it is some pretty sparks and a little bit of induction. If you want some fun take a Tesla Coil and wind a 5 turns of the Antenna around a large 480v 80uf Run Cap. Put an Averenko diode plug on the cap terminals and earth the tail. Then short the cap with a screwdriver:) Warning Don't Touch the Cap terminals!
[4/4] Re: [EVGRAY] Energy harvesting Weigand
2018-09-10T12:24:29+00:00
·
onielsen2000
<[email protected]>
Message-ID:
<[email protected]>
Hi James, Be very careful if doing that. There are some safety rules to prevent hazards that must be followed: https://electrical-engineering-portal.com/7-golden-safety-rules-for-working-in-hv-laboratory https://electrical-engineering-portal.com/7-golden-safety-rules-for-working-in-hv-laboratory Regards Ole ---In [email protected], <jglinski01@...> wrote : Thanks silver that was a pretty good answer rich in coverage . I have felt if we could replicate teslas discovery simply as he described were it charges everything in the room and down stairs as well .we will have it down to its simplest form and can go from there .anywhere. The base conditions . that would show the similarly with don smith's work and bedini's as of shoots of Tesla in a easily relocatable form . thanks again . jim On Sep 8, 2018 8:29 PM, "Jonathan Rivera einspace2005@... mailto:einspace2005@... [EVGRAY]" <[email protected] mailto:[email protected]> wrote: Will keep paying attention on your progress. Thanks. einspace
← Previous
Page 1 of 1
Next →