High Current Plasma Physic

"For high voltage keep the capacitance low and inductance high. For high current keep the capacitance high and inductance low."

Thank you very much for pointing out this important truth - Ole

High Current Plasma Physic:

http://e-catworld.com/2018/05/08/does-brilliant-light-power-reactors-run-on-overunity-too-a-speculation/ http://e-catworld.com/2018/05/08/does-brilliant-light-power-reactors-run-on-overunity-too-a-speculation/

Both Randell L. Mills with his SunCell and Andrea Rossi E-Cat QX uses high ampere low voltage to ignite the plasma. Both devices gives of heat.

Alexander V. CHERNETSKII
 
 [ Chernetski / Chernetsky ]
 
 Self-Generating Discharge Plasmatron

 "In the later experiment with an input power of 700 watts, that extracted by the generator loads resistance was three kilowatts, or nearly five times more."

http://www.rexresearch.com/chernetskii/chernetskii.htm http://www.rexresearch.com/chernetskii/chernetskii.htm 

If Chernetsky used a 10 volt battery. The current amplifing high frequency circuit used 70 ampere.

Something to ponder over and read:

http://gratisenergi.se/sparkgap.htm http://gratisenergi.se/sparkgap.htm

Best Wishes, Hermes

P.S If you can mix high voltage/low current (like a camera flash, high voltage Television Tube driver  or a Car Ignition Coil) with low voltage/high current (100Ah) then you have free energy like Tibor Kemeny:

http://gratisenergi.se/kemeny.htm http://gratisenergi.se/kemeny.htm