EVGRAY Archive

zinc cases

3 messages · 2018-03-20T08:46:10-07:00 → 2018-03-21T07:52:29-07:00

[1/3] zinc cases

2018-03-20T08:46:10-07:00 · Mick <[email protected]>
Message-ID: <[email protected]> 
Sourcing zinc cases without destroying batteries is more difficult than
expected.

Based on the notes pointed out by Norm, pg25 Colorado Springs, Dr Tesla
made some intriguing batteries that appear to be air filled and
connected in an odd parallel series config.  If in case one desired to
duplicate this setup the materials called out are zinc containers rubber
stoppers with a hole drilled in the middle for a carbon rod to fit in.

If anyone has a good source for this please post.

Thanks,

Mick

[2/3] Re: zinc cases

2018-03-20T20:18:51+00:00 · triadutrad <[email protected]> <[email protected]>
Message-ID: <[email protected]> 
going back into the EV gray tubes ? 

(H) 


 

---In [email protected], <mkjekyll@...> wrote :

 Sourcing zinc cases without destroying batteries is more difficult than
 expected.
 
 Based on the notes pointed out by Norm, pg25 Colorado Springs, Dr Tesla
 made some intriguing batteries that appear to be air filled and
 connected in an odd parallel series config.  If in case one desired to
 duplicate this setup the materials called out are zinc containers rubber
 stoppers with a hole drilled in the middle for a carbon rod to fit in.
 
 If anyone has a good source for this please post.
 
 Thanks,
 
 Mick

[3/3] Re: [EVGRAY] Re: zinc cases

2018-03-21T07:52:29-07:00 · Mick <[email protected]>
Message-ID: <[email protected]> 
No page 25 Colorado Springs the one Norm turned us on to.


On 3/20/2018 1:18 PM, [email protected] [EVGRAY] wrote:
>  
>
> going back into the EV gray tubes ?
>
> (H)
>
>
>
>
> ---In [email protected], <mkjekyll@...> wrote :
>
> Sourcing zinc cases without destroying batteries is more difficult than
> expected.
>
> Based on the notes pointed out by Norm, pg25 Colorado Springs, Dr Tesla
> made some intriguing batteries that appear to be air filled and
> connected in an odd parallel series config.  If in case one desired to
> duplicate this setup the materials called out are zinc containers rubber
> stoppers with a hole drilled in the middle for a carbon rod to fit in.
>
> If anyone has a good source for this please post.
>
> Thanks,
>
> Mick
>