AW: Re: Calculations on trafo - Re: AW: [EVGRAY] Re: Kone & Hector, you guys finally did it!

Hello Hector, I can with my voltage peak circuit even after the max. peak switching, more can not be done in this way as a phase control. In addition, I now have 2 inductors which are steplessly adjustable from 0 to 12 Henry. Both variacs I use as adjustable inductor are designed for 2.5 kva. It is difficult to set the even switch at all. Maybe I find someone who films me while I shut down the system. laughing. Greetings Sven

Von Samsung Mobile gesendet

-------- Ursprüngliche Nachricht --------
Von: "[email protected] [EVGRAY]" <[email protected]> 
Datum:03.02.2018  17:04  (GMT+01:00) 
An: [email protected] 
Betreff: Re: Calculations on trafo - Re: AW: [EVGRAY] Re: Kone & Hector, you guys finally did it! 


The timing is the key as not to go off cycle from the sequence of events ...

and sorry got no pics on that  to post ..

(H) 
 
---In [email protected], <s.friedrich@...> wrote :

Hello Hector,

It is really difficult to get two identical reactors or transformers or inductors and to adapt them with single turns.

I'm going now another way and install Variacs as Adjustable Reactors. I have one of the 2500VA here and that can be set from 0 to 250 volts. The transformers are very effective as they have low line resistance and high inrush current. I think they are optimal to work as a reactor. So you can adjust the impedance optimally to the capacitor.
Do you have a scope picture of how the discharge should look like?
If I have the 2 transformer I will make a video and show how the curve changes on the scope.

I have now experimented with a digit transformer to test how everything is about and I think that this is promising. The voltage increased in the capacitor to over 1 KV. With a transformer, of course, I get no symmetry out. With 2 position transformers you can then fine tune during operation.

regards

Sven