Re: AW: [EVGRAY] Re: buck plug ...

Sven,

Crack open the inverter, see if you can add a capacitor trim to the 
frequency, a touch may be all you need.  I had similar problem in the 
ZVS inductor circuit until I lowered the IW capacitance of my coils 
therefore raising the frequency.   After this all parts ran cool.


On 1/8/2018 11:39 AM, 'S.friedrich' [email protected] [EVGRAY] wrote:
>
> I can adjust the switching points only for the voltage in the diode 
> plug. I'm already switching to the peak. The only thing that comes to 
> my mind is to design the reactors stronger so that a higher cold 
> current flows there!?! Greetings Sven
>
> Von Samsung Mobile gesendet
>
>
> -------- Ursprüngliche Nachricht --------
> Von: "[email protected] [EVGRAY]"
> Datum:08.01.2018 14:59 (GMT+01:00)
> An: [email protected]
> Betreff: [EVGRAY] Re: buck plug ...
>
> need to shift the COLD side of the current node to the SCR internals ....
>
> in other words there is a POINT within the TUNING of THE L-C SCR will 
> run COLDER ...
>
> (H)
>
>

I can adjust the switching points only for the voltage in the diode plug. I'm already switching to the peak. The only thing that comes to my mind is to design the reactors stronger so that a higher cold current flows there!?! Greetings Sven

Von Samsung Mobile gesendet

-------- Ursprüngliche Nachricht --------
Von: "[email protected] [EVGRAY]" <[email protected]> 
Datum:08.01.2018  14:59  (GMT+01:00) 
An: [email protected] 
Betreff: [EVGRAY] Re: buck plug ... 

need to shift the COLD side of the current node to the SCR internals ....

in other words there is a POINT within the TUNING of THE L-C SCR will run COLDER ...

(H)

Your right my bad ...it's MOSFETs that that  Applies too.
On Jan 8, 2018 12:26 PM, "Mick [email protected] [EVGRAY]" <
[email protected]> wrote:

>
>
> Sven,
>
> Crack open the inverter, see if you can add a capacitor trim to the
> frequency, a touch may be all you need.  I had similar problem in the ZVS
> inductor circuit until I lowered the IW capacitance of my coils therefore
> raising the frequency.   After this all parts ran cool.
>
> On 1/8/2018 11:39 AM, 'S.friedrich' [email protected] [EVGRAY] wrote:
>
>
>
> I can adjust the switching points only for the voltage in the diode plug.
> I'm already switching to the peak. The only thing that comes to my mind is
> to design the reactors stronger so that a higher cold current flows
> there!?! Greetings Sven
>
> Von Samsung Mobile gesendet
>
>
> -------- Ursprüngliche Nachricht --------
> Von: "[email protected] [EVGRAY]" <[email protected][EVGRAY]>
> Datum:08.01.2018 14:59 (GMT+01:00)
> An: [email protected]
> Betreff: [EVGRAY] Re: buck plug ...
>
>
>
> need to shift the COLD side of the current node to the SCR internals ....
>
> in other words there is a POINT within the TUNING of THE L-C SCR will run
> COLDER ...
>
> (H)
>
>
> 
>