Re: [EVGRAY] Energy harvesting Weigand

Body

Thank you silver for your kind explanation . if you might keep talking
about this as your spirit will permit it will help a lot of us on the forum
to understand it completely .never underestimate the insite of your friends
on the form .some are high some not so much as when dealing with a new
concept . getting this resolved and anchored as bed rock would be a good
foundation for everyone .
On Sep 14, 2018 3:02 PM, "[email protected] [EVGRAY]" <
[email protected]> wrote:

>
>
> You dont need a lot of power, large powerful arcs are certainly not
> required. Use a single transistor Kacher Bovine tesla coil or TV Flyback.
> Better to use Direct Digital synth to generate RF to 0.1Hz resoultion which
> is what i have just built.   2 amps is more than enough or about 1/4 inch
> streams to screwdriver tip. The trick is all in the timing to hit the sine
> peaks like Kone does but that is when your HV packet is turned on.  You
> need a push pull driver too and some hefty large ferrite rings or TV yoke
> to make a traffo. Run it between 20khz to 50khz. Got to find the sweet spot
> for your setup.  When a coil is tuned for max VARS standing wave like RV
> you can have huge amps and volts in circulation but very little real
> current loading. Some of this reactive current measured with amp clamp ie
> 250 amps is skewed during the sine whacking and converted to real amps
> perhaps 10% skew = 25 amps and the tesla voltage is added to peak sine
> values lets say 200v * 25 amps = 5kw. This is Kapanadze, Ruslan, Akula,
> ROman, Peridov sysem basis.  There is now at least a dozen public
> replications of this in the last few years mostly from Russia, Latvia,
> Ukraine, Poland etc. I think they have learnt to keep the TV turned off:)
>
>
> ---In [email protected], <schoonersolsticemoon@...> wrote :
>
> Silver
> Your description seems very easy to build and is amazingly straight
> forward.
> I wonder if the signal
> from my model T Ford coil, rectified,
>  might work?
> What does one do next?
> You have a 10,000 volt dc spark discharge. How do you best use this
> eruption of the magnetic field, to harvest energy?
> Cheers Warren
> Sent from Yahoo Mail on Android
> <https://go.onelink.me/107872968?pid=InProduct&c=Global_Internal_YGrowth_AndroidEmailSig__AndroidUsers&af_wl=ym&af_sub1=Internal&af_sub2=Global_YGrowth&af_sub3=EmailSignature>
>
> On Thu, 13 Sep 2018 at 2:39 AM, silverhealtheu@... [EVGRAY]
> <[email protected]> wrote:
>
>
> The packet burst is basically a wrapper. In practice the timing will be
> done today using microcontroller, TTL logic or 555 timers etc to turn on
> and off the Tesla Coil. You need basically DC pulses so TV flyback is ok as
> they already got a diode and use that to punch the magnetic field.  The
> trigger will be some rising sine wave on the RX coil of interest and a
> schmitt trigger can be used to detect the rising edge and set your timers
> for nanosecond delays.  So very similar to Kone's Sine Wave shorting
> circuit except use Tesla to whack the sines.
>
> 
>