Re: [EVGRAY] Energy harvesting Weigand

Body

Silver.  So  a flyback driven by a MOSFET and a 555 timer .I've seen two
555's with clipping diodes working together to control all of the wave form
.and punctuate the signal. Think a cap and dump setup will go well with
this there's one I like with a neon trigger it dumps at around 100 volts
orc does this need to be pure cold electrical to the lead acid batteries .
I would like to use a Tesla power wall with this .double effency ...100
times lighter ..no acid and individual cell replacement when one fails .and
can be increased like a bank account weekly .when funds are available . if
I dump the cap into a very large cap to smooth out the pluses and maybe a
choke to and use a DC to converter to control voltage I might make the
lithiums work . I have a eight banger coil from a Bedini build I might use
.this core concept needs to be re-established and made simple for
everyone's use. hate to think it was lost in time for the third time and
just gone . thinks silver
On Sep 13, 2018 1:39 AM, "[email protected] [EVGRAY]" <
[email protected]> wrote:

>
>
> The packet burst is basically a wrapper. In practice the timing will be
> done today using microcontroller, TTL logic or 555 timers etc to turn on
> and off the Tesla Coil. You need basically DC pulses so TV flyback is ok as
> they already got a diode and use that to punch the magnetic field.  The
> trigger will be some rising sine wave on the RX coil of interest and a
> schmitt trigger can be used to detect the rising edge and set your timers
> for nanosecond delays.  So very similar to Kone's Sine Wave shorting
> circuit except use Tesla to whack the sines.
> 
>