Re: Aw: Re: AW: Re: [EVGRAY] Low Lenz in plain sight

Body

"Yes"!   Ole thanks for the schematic to explain the Y transformer 
common neutral!


On 8/4/2018 4:20 AM, [email protected] [EVGRAY] wrote:
>
> Hi George,
>
> In the US the phases are split in two halves with a neutral in the 
> center instead of using three phases.
>
> From Wikipedia:
>
>> Split-phase electric power 
>> <https://wiki2.org/en/Split-phase_electric_power>
>>
>> A *split-phase* or *single-phase three-wire* system is a type of 
>> single-phase <https://wiki2.org/en/Single-phase_electric_power> 
>> electric power distribution. It is the AC 
>> <https://wiki2.org/en/Alternating_current> equivalent of the original 
>> Edison three-wire direct-current system.
>> Fig. 1
> Regards
> Ole
>
>
>
>
> ---In [email protected], <canowindracd@...> wrote :
>
> Norm,
>
> Here in Australia when we say it is single phase, we mean it is one 
> phase of the three phase 415 volt supply and the neutral and this 
> gives us 240 volts.
>
> How do you get a single phase supply without a neutral over there?
>
> George
>
>
>
>     On Saturday, 4 August 2018, 9:34:57 am AEST, Norman Wootan
>     nwootan@... [EVGRAY] <[email protected]> wrote: 
>
>
>
> Mick!  I really do not understand what it is that you do not 
> understand!   There have been two different scenarios with my bench 
> top simulation of the Neutral Spike experiment where the effect was 
> successfully created. The last one was with a 5HP A/C compressor that 
> uses both start and run capacitors needed to create the effect. Go 
> back and review the whole setup that I have posted to the group 
> several times. The iron motor frame was bonded to a 10 ft. ground 
> stake (EARTH BOND).  The 230VAC supply to the motor was 2 ea. 8ga. 
> conductors (L-1& L-2) with no neutral (single phase hook up). When an 
> adjustable (locked rotor current detector)  over current relay would 
> drop out L-1 & L-2 supply to motor leaving it in an isolated condition 
> since there was no neutral in schematic. You have a magnetically 
> saturated motor and charged capacitors that are separated from the 
> earth bonded metal frame via the dielectric in the insulation 
> involved. In both cases, I found that the isolation of charge (both 
> magnetic flux and electric via capacitors (45mfd) created the EMP 
> (Neutral Spike when the stored energy was cancelled.   The very first 
> encounter was with the little 1/6 HP fan motor that created the same 
> effect as the big experiment. That case there was a zip cord (3 ea. 18 
> ga. conductors)  L-1 ,a neutral and an earth green bonding wire 
> involved.  Due to a Chinese worker miss wiring a double pole reversing 
> switch which caused the isolation of the run capacitor when the switch 
> was in transition from forward run to reverse, the EMP shot was 
> created. The whole thing is summed up with isolation of charge, both 
> magnetic and electric charge!
>
>
> On 8/3/2018 10:07 AM, Mick mkjekyll@... <mailto:mkjekyll@...> [EVGRAY] 
> wrote:
>>
>> Norm,
>>
>> Can you define the neutral spike with and without the earth ground 
>> involved?
>>
>>
>> On 7/31/2018 5:40 AM, Norman Wootan nwootan@... <mailto:nwootan@...> 
>> [EVGRAY] wrote:
>>>
>>> Doug & Warren, I love your thinking process for designing a circuit 
>>> (Ardino ?)  that rapidly tracks the capacitance values needed to 
>>> zero in on the targeted frequency for hard ferroresonance. Since 
>>> solid state will not survive the environment, just use the circuits 
>>> to control hard tubes like the thyratron do do the heavy lifting. 
>>> Auto tracking circuits can be made to mitigate (avoid) the 
>>> ferroresonance phenomenon, therefore the same circuit can auto 
>>> target the values needed to capture the circuit parameters needed.  
>>> Just my two cents thrown in, soon we will have a whole $dollar! 
>>> Lol   PS: Doug, I like the Fuck it, just Short Circuit! On my 5 HP 
>>> compressor locked rotor experiment, I used a simple overload relay 
>>> which was set for drop out at locked rotor amps (82 amps) which gave 
>>> me the super saturation of the motor iron when the 2 pole single 
>>> phase contactor (230 VAC) opened thus leaving the whole shebang in 
>>> an isolated condition (no ground reference). When the isolated 
>>> energy (magnetic saturated iron and 45mfd caps) cancelled, I got the 
>>> EMP shot in the earth ground, Neutral Spike.   Your thinking is 
>>> right on! Norm
>>>
>>>
>>> On 7/31/2018 6:22 AM, Warren Keillor schoonersolsticemoon@... 
>>> <mailto:schoonersolsticemoon@...> [EVGRAY] wrote:
>>>>
>>>>
>>>> Doug
>>>>
>>>> What is the cheapest, simplest, detector for peak voltage?
>>>> With such a detector, the signal can then close a heavy duty switch.
>>>> If it can chase the sine wave, where ever it goes, then you should 
>>>> be able to harvest the maximum energy.
>>>> Detectors: we should make a list of every possible peak since wave 
>>>> detector, for consideration.
>>>> Switches: relays, electronic, and mechanical methods of closing the 
>>>> circuit at the peak of the since wave, should be also listed.
>>>> This energy works. We know it is there. It burns out brushes, and 
>>>> commutators, and heats up power tools.
>>>> We also know we can bleed it off with diodes, to use in yet another 
>>>> motor, and actually see the voltage increase, from one motor to 
>>>> another, with permanent magnet DC motors.
>>>> The beauty of a solid state transformer based device, is that there 
>>>> are no friction producing parts rubbing together, turning to powder 
>>>> as it runs.
>>>> Cheers Warren
>>>> Sent from Yahoo Mail on Android 
>>>> <https://go.onelink.me/107872968?pid=InProduct&c=Global_Internal_YGrowth_AndroidEmailSig__AndroidUsers&af_wl=ym&af_sub1=Internal&af_sub2=Global_YGrowth&af_sub3=EmailSignature>
>>>>
>>>>     On Tue, 31 Jul 2018 at 12:42 AM, konehead@...
>>>>     <mailto:konehead@...> [EVGRAY]
>>>>     <[email protected]> <mailto:[email protected]> wrote:
>>>>
>>>>     Hi Warren
>>>>     Just my two pcents but the variables to create ferroresonance
>>>>     and also resonance let's say in Air coil too, seen to be
>>>>     frequency, capacitance and inductance....however perhaps there
>>>>     is the fourth dimension overlooked which is extraction of this
>>>>     energy, not just the observation or prediction of it or the
>>>>     cancelling or avoidance of it which usually seems to be the
>>>>     "scientific purpose".....
>>>>     As Sven is doing with diode plug exprimemts too,, he is
>>>>     extracting it into a load ( and not direct lump resistance.load
>>>>     as is shown in figure drawings)
>>>>     And so the distribution of the positive or negative energies in
>>>>     sinewave via running through diodes into what I call collector
>>>>     caps, .
>>>>     and only the collector caps see or feel effects of resistive
>>>>     load (and only discharged to resistive load when isolated and
>>>>     independent and disconnected more or less from the system or
>>>>     circuit that filled these caps)
>>>>     now this brings upon not only the fourth dimension of "means of
>>>>     extraction" from the "resonant collecting caps" but also there
>>>>     becomes the fifth dimension of time and timing of how long and
>>>>     when to fill and discharge the resonant collector caps
>>>>     Also as caps fill over time, and when they discharge and refill
>>>>     they again change the ferroresonance or resonance "parameters"
>>>>     of primary system that fills caps.
>>>>     My sick plan is to fuck it all, instead SHORT CICUIT
>>>>     inductorsvery briefly with switch at peak periods, this cause
>>>>     hypernringing within coil and gives you simulation of resonant
>>>>     condition since you have same effects you want in extraction
>>>>     and that is voltage increase into capacitors X 20 or X 50 in
>>>>     magnitude.
>>>>     Also short can be applied to AC or DC impulse take your
>>>>     pick...with DC it is done just before saturation, with AC,
>>>>     at.voltage peak periods.
>>>>     Kone
>>>>
>>>
>>
>
>