Re: Aw: [EVGRAY] Re: Push pull generator.

Body

Hello Ole,

I looked at the PDF and added one from Toshiba where on the last page you should put a capacitor between gate and source, I used a very small one with 10nF.


For me, C1 is 1μF MKP and C2 is 68μF Elko.
R2 2.2 ohms and R3 now 10K.

I've twisted all the wires and connected, unfortunately, I can not keep the lines so short by my design, but I only work with frequencies from 37 to just over 600 Hz.

I send some Scope pictures I have the feeling that the Mosfet switch clean and the small disturbances do not affect them, at least if you look at the scope pictures from the power section.

What surprises me is that my Scope probably disturbances in the system brings at least at small pulse widths a signal from whatever. The scope is grounded if there are leakage currents flowing over it?!?

regards

Sven