Body
Hello Norman, producing this neutral spike is quite difficult. Did you just ground your motors over the case? I'm unloading the capacitors into a pushpull trafo I have not grounded yet. I had already thought about connecting the Den FR resonance circuit to the earth with a diode to suck in additional energy. Maybe it's really easier to go back to the beginning. Does that mean practically that the neutral spike is transformed into the winding via the core? Greetings Sven
Von Samsung Mobile gesendet
-------- Ursprüngliche Nachricht --------
Von: "Norman Wootan [email protected] [EVGRAY]" <[email protected]>
Datum:12.04.2018 19:52 (GMT+01:00)
An: [email protected]
Betreff: Re: Fwd: Re: [EVGRAY] buzzer OU
Thank You all! for the discussion regarding the creation of Neutral Spike & ferroresonance phenomenon! If you will go all the way back to Tesla Telagraphy 101, explained on page 25 of the Colorado Springs Notes, you will understand how Tesla was able to use approximately 200VDC (batteries in series) to provide a unidirectional (DC pulse) of 20 miliamps into the ground system. He used a permanent magnet core coil and a gas filled pulse tube which gave a break-over conduction from a relay provided de-magnification pulse at tube allowing conduction. This was learned when Tesla built the magnetic rectifier for the New Your street light which were run on DC prior to his AC electrification of New York. I the Wardencliff tower, magnifying transmitter, there was an expansive radial conductor ground system which provided the necessary bonding to the earth. All of this followed Tesla sending control signals to his little submarine boat on the Hudson River. First ever remote radio control using earth and water as a signal carrier. Rogers got the concept of his Underground Antennae from Tesla experiments. My (easily replicated) experiments with locked rotor 5 HP compressor motors producing Negative Spikes is an example of relative low voltage production of the phenomenon. 230VAC @ 82 amps is low power to me. Yes! The earth response is very high voltage blast at super high currents which cannot be me4asured or quantified. Our challenge is to capture and utilize this strange power just as we had proposed for the controlable production of the ferroresonane phenomenon. The trick is to be able to create a sustained chain of events so we an possibly transfor the high voltages and current into a useable power output. See the numerous articles I put up on ELF that is all driven by underground and under water signal flow. Roger's original antennae used a lead pipe buried under ground.
On 4/12/2018 10:11 AM, Mick [email protected] [EVGRAY] wrote:
Correction --"current flow" only appears between differentials otherwise current is a scalar and we are back to the bird on the wire.
On 4/12/2018 6:05 AM, Warren Keillor [email protected] [EVGRAY] wrote:
Hi Mick
You are right!
The ground makes a huge difference.
The Smith device concept is correct on this point, according to Kurt's latest experimental results.
I need to figure out how to make a good ground here, where I am located.
I had just put down a nice 10' long steel rebar at my home/workshop, before we moved here, where there is sedimentary rock only a few inches under the sod.
If you were to see a cross section, it looks like layers apon layers of limestone blocks, along with even harder sandstone layers.
Can this be a ground?
I do have a pair of water wells, one that is over120 feet deep. Can I ground to the well casing?
I used to communicate with a ham operator located somewhere near this area who had a beam antenna giving him an extraordinary signal even to me to my boat in Venezuela.
Sadly, he has since passed away.
He had purchased his property based on the radio propagation capability. He used to connect telephone patches to my parents, so we could chat before cell phones came in.
I have hopes, I too, can get a ground connections, for Smith experiments.
Another ground source might be the result of our fence contractor who will be putting in page wire perimeter fences, using steel t bar posts driven into the rock, using pnuematic jack hammer post drivers.
I should be able to get a ground off this fence, as well, I hope.
Zilano manages to run her farm on 160 kw of 250 volt 50 hz table top unit.
Man! I can certainly use that around here, after this last winter's heating bills came home.
Toronto is in Ontario's banana belt, by comparison to here, in Eastern Ontario.
Cheers Warren
Sent from Yahoo Mail on Android
On Thu, Apr 12, 2018 at 3:43 AM, Mick [email protected] [EVGRAY]
<[email protected]> wrote:
Warren,
If one takes what Norm says to heart, which I don't know why one wouldn't as he has a hand up on most of us, the issue on your Smith device needs to be tuned to make a neutral spike and receive the ping back. Look up "lightening return strike" Start with getting the spike then tune for the proper phase to suck it back in.
First you have to be able to send the proper width and amplitude pulse and then receive the echo from a well grounded rod. Part one use a battery to undertake this experiment as many bench supplies and such I think cause problems with their grounding scheme interfering with this. Part Zero- don't forget the ground, even Don Smith said it would not operate without a ground. You can't get something for nothing plain resonating is just that until it is taken to the point of such high Q that it pumps a core like a laser then there are some nuclear resonant points one can derive energy from. On the other hand the neutral spike sounds like a much easier way to source extra power.
On 4/11/2018 12:26 PM, Warren Keillor [email protected] [EVGRAY] wrote:
James
You are correct about the high voltage pulses.
I'm not sure what the mechanism is, but I have read it is better.
Zilano seems to have written that it is possible to do a lower voltage version, that is less efficient.
Of course, the real magic was done with a kv.system.
I have yet to replicate Zilano's devices, with success.
They seem to be easy to make, but a little short on hands on, idiot proof instructions, with ample feedback.
We have to keeo trying
Cheers Warren
Sent from Yahoo Mail on Android
On Wed, Apr 11, 2018 at 12:42 PM, James Glinski [email protected] [EVGRAY]
<[email protected]> wrote:
Warren don't leave out the hi voltage power needle pluses. That's important .
On Apr 11, 2018 11:22 AM, "Warren Keillor [email protected] [EVGRAY]" <[email protected]> wrote:
Sven
You are going too fast for me.
Give some context to what you are referring to transformers.
You mentioned the Earth.
Transformers as I understand them, are able to capture hertzian waves that can circulate through them as current.
I have been led to believe that two coils can resonate in magnetic proximaty to each other avoiding Lenz's law, providing the frequency is compatible to the wire length of each other.
The coil length is very important, but can be very low impedence fat wire, or even copper tubing making the helix, as long as it is a harmonic of the other coil(s) sharing that magnetic field so they resonate together.
Capacitors can be used to adjust the tuning, as can changing the helix lengths so resonance can be achieved.
Losing lenz's law, yet transfering energy, is difficult, as we all know, and each workable method is a treasure of a tool to work with.
The trick, if it is a trick, is to have a nice big tool kit, to design with.
Cheers Warren
Sent from Yahoo Mail on Android
On Wed, Apr 11, 2018 at 10:00 AM, [email protected] [EVGRAY]
<[email protected]> wrote:
Hello Ole,
ok the capacity of the transformer is the keyword it flows in over the earth?!? That would be free energy over ground potential ????
That would have to work with every other transformer, too, or is the extreme high impedance important, since the number of windings appears to add capacitively.
What and how should we proceed to get positive results. For me, everything speaks for the electric field