Re: Aw: Re: Re: [EVGRAY] Re: Strobe Experiment [1 Attachment]

Body

Beautiful Sven you have style! 

Where do you get the giant heat sink?

Is the transformer to the right side outside the frame of the picture?



On 3/22/2018 9:51 AM, [email protected] [EVGRAY] wrote:
>  
> Hi Warren, in your case you want to pull out of the capacitor phase
> energy to do anything.
>
> When Coilbanger I can not change the current direction, the coil has
> the endeavor to maintain the current direction, it acts like a
> battery. Through the transformer I can change the direction of current
> and lead it back into the capacitor - that's the idea.
>
> I have finished my new diode plug system now or finished last week.
> With the new components, everything can be set even more precisely and
> cleanly. I have now attached flywheel diodes with 75W bulbs to the
> anodes of the SCRs. So you can visually see the strength of the
> impedance or how much energy is transferred or not at high impedance
> shine brighter as at low impedance, it may be a bit of gimmick.
>
> I have perfected the system, the question now is how do I use these
> short strong impulses now. With 400 to 500V pulses directly to the
> battery switch, because I have no good feeling.
>
> I would like to build a universal buck converter, I still have a few
> components to build the rough and a HF core synonymous. Just take a look.
>
> regards
>
> Sven
>  
> *Gesendet:* Donnerstag, 22. März 2018 um 16:25 Uhr
> *Von:* "Warren Keillor [email protected] [EVGRAY]"
> <[email protected]>
> *An:* "[email protected]" <[email protected]>,
> "[email protected]" <[email protected]>
> *Betreff:* Re: Aw: Re: [EVGRAY] Re: Strobe Experiment
>  
>
> Sven
>
> It might not be the same situation, but with my RV, I did drive yet
> another RV identical to the first one, without a transformer.
> It didn't prove anything, perhaps, except that the transformer in
> series with the capacitor circuit was not in all cases essential, with RV.
> One RV had grease, and seals, the other had been cleaned, but they
> were identical 3 hp WEG 480 volts 3 phase.
> Cheers Warren
>  
> Sent from Yahoo Mail on Android
> <https://overview.mail.yahoo.com/mobile/?.src=Android>
>  
>
>     On Thu, Mar 22, 2018 at 11:04 AM, [email protected] [EVGRAY]
>     <[email protected]> wrote:
>      
>
>      
>
>     I also think that you have to use a transformer to send the energy
>     back in the right direction, preferably with higher voltage.
>
>     regards
>
>     Sven
>      
>     *Gesendet:* Mittwoch, 21. März 2018 um 19:51 Uhr
>     *Von:* "Dave Muckerman [email protected] [EVGRAY]"
>     <[email protected]>
>     *An:* "[email protected]" <[email protected]>
>     *Betreff:* Re: [EVGRAY] Re: Strobe Experiment
>      
>
>      
>
>     For the (H) coil bangers here:
>     I think a small choke winding series to diode across flash tube is
>     needed for PIV protection, stopping nasty 6KV+ trigger pulse.
>     Diode keep lamp from ionizing too.
>      
>     OR  fire lamp into auto-transformer, side-winding-diode recharges
>     the lamp storage cap. and forget about diode across to lamp.
>     Easy to wind a pulse transformer and you rewind it until perfect.
>      
>     A great new source for cheap HV non-polar hi freq. tough
>     capacitors. Induction stove MKPH 5% type. 600v up to 1200, & up to
>     1 ufd
>      values. good up to 150khz and self healing too.
>     E-bay, write the seller for discount for 16 or so
>      
>     ATTN: (H)
>     (Unless energy reverses on the banged coil back through the diode
>     across lamp as (H) writes and it refills the cap or writes in
>     foolproof hookup detail.)
>      
>      
>
>      
>     On Wednesday, March 21, 2018 12:47 PM, "[email protected]
>     [EVGRAY]" <[email protected]> wrote:
>      
>      
>     Kapednaze = genesis
>
>     "self cancelling opposed fields and a turn rate defined variometer
>     magnetic field angle modulation"
>
>
>
>
>     (H)
>      
>
>      
>
>      
>
>      
>      
>      
>
>  
>
>