Re: AW: Re: AW: Re: Aw: Re: Re: Re: Re: AW: [EVGRAY] Re: "Impressive"!

Body

Hi Ole,

you just have to create a low impedance at the push-pull transformer. The problem is that this transformer is just a isolating transformer so the voltage is not down-converted to 24 volts.

The 230/24 volt transformers I have to connect to the secondary side of the pushpull generates a higher impedance which ensures longer switching times at the SCR.

I have already considered whether to connect the secondary coil of the push-pull transformer with a FWBR and conducts the energy in a mains choke and then connect in the battery with flyback diode as a step-down converter with only 50 Hz or 2x 230V / 24V transformers in parallel to the secondary winding to lower the impedance.

The only question is when the 24V winding is connected with a FWBR to the battery, the battery will act against it with its own voltage and create additional impedance in the push-pull transformer.

The easiest way would be to connect the secondary winding directly to the battery and to charge it with the energy peaks.

I'm just not comfortable because the batteries are in excellent condition and I do not want to destroy them.

regards

Sven