Re: AW: Re: Aw: Re: AW: Re: AW: Re: AW: Re: Re: Re: AW: Re: AW: Re: Re: AW: Re: Re: AW: Re: Re: Re: AW: [EVGRAY] Re: All information about Diode Plug.

Body

Hi Ole,

did you watch my video with the attempted setting, if I go beyond a certain point loses the signal. But you clearly see that not much is missing to have the sinus again as it was before.

Yesterday I once again measured the impedances with 150 volts, unfortunately my Variac shaft no longer because he is not designed for such a performance.

About the inverter, I have connected the Variac gives off a much more constant performance as our power grid.

The individual push-pull windings are at 90 ohms impedance and with full load maybe 1-2 ohms. Since I can only give minimal tension on the winding and the power consumption increases extremely. The coupling of this transformer is extremely good, I think.

Now I wanted to test the secondary winding as a push-pull, although it has a little more impedance but the difference between the two windings is only 1 milliampere current flow at the same voltage. I think these windings are most similar.

regards

Sven