Re: AW: Re: Aw: Re: AW: Re: AW: Re: AW: Re: Re: Re: AW: Re: AW: Re: Re: AW: Re: Re: AW: Re: Re: Re: AW: [EVGRAY] Re: All information about Diode Plug.

Body

Hi Sven,

The Edison way of distributing power with big impedance mismatch by having the voltage staying almost constant during different loads doesn't work too good for a resonating circuit as any change in impedance will affect the resonant frequency. Without any compensation the load must stay constant. I believe that is what the diode plug is for. It keeps the resonant frequency at a constant frequency by only allowing the load to see the capacitors instead of loading the LC-tank of the Ferro resonant transformer. This probably requires that each capacitor is connected for a full charge transfer like reaching the peak voltage before switched to the load.

The triggering circuit fires at a preset voltage level no matter if this is actually the peak voltage. Perhaps this is wrong. Discharge should happen after or earliest at the peak voltage.

Regards
Ole
 

---In [email protected], <s.friedrich@...> wrote :

 Hi Ole, I assume that I have a clean sine wave at the reactive power generated in the transverter in the transmission over the coupling capacitors changes nothing except that everything is shifted by 180 degrees. If I now turn on the diode connector, this sine wave will change, I hope, at least by switching the thyristors. If you now set the switch so that is within the voltage time, the half LCs should be united again. It all works perfectly well thanks to your help, but that you can just connect any load as in a conventional way is a misconception of me or I have probably misinterpreted in the descriptions.

regards

Sven