Body
Nice tracked Cat with bucket there Warren!
That transformer looks like it could run you whole house.
It would cost one arm and one leg down here in Australia!
Wish I had some way to make it happen for us all ...the free energy I mean.
You guys up there in the temperature extremes need it more than us.
Phew it looks cold.
This is a bit unrelated but there's a Russian guy on YouTube who hooks up
three standard single phase transformers across each of the 3 power phases.
He used toroidal's in video........A to B , B to C and C to A.
Then he connects all 3 of the the transformer outputs in parallel.
He says that because of the 60 degree offset betwen phases the energy
consumed is being used at 60 degrees offset from the input, (near as I can
gather).
Cosine of 60 is 0.5.
So it results in a net gain, I don't quite understand but thought it might
be worth to pass along as a simple thing to try if you have 3 phase
Gerry.
On Sat, Feb 3, 2018 at 12:40 AM, Warren Keillor
[email protected] [EVGRAY] <[email protected]> wrote:
>
>
>
>
> Hi guys
> I invited a little cat into the home to help me with the heavy lifting.
> This is my 450 lb 3 phase transformer that has made the move, and has been
> unpacked and carried into the stone barn which I am to use for my
> experimental studio.
> I have been lucky with a break in the weather, allowing me to drag home
> this 2 ton machine from 5 hours away from here. We are expecting another
> blizzard.
> It is nice to have some hydraulic muscle
> around the home.
> The whole machine is driven by one hydraulic pump, which is turned by a 3
> cylinder Mitchibushi diesel.
> It runs fine but can be replaced by an electric motor.
> Many of our over unity devices are not very flexible regarding loading.
> Thos concept might be an answer.
> You load a hydralic system to a particular pressure, which is stored in an
> accumulator tank.
> That way, the engine and pump run at a fixed load and rpm, while the rest
> of the machine is meeting periodic demands of the load
> This solves an issue with anyone wanting to set their RV tuning and leave
> it that way.
> As far as the machine goes, I'm just a little guy, and have a lot of 500
> lb stones that my place is built from. I am building a hydraulic lower jaw
> on the bucket called a "thumb" so I can grab on to rocks and debris, fixing
> this place up.
> While learning to drive it, I am unpacking my energy gear.
> Today, I am going to try to move a big cast iron flywheel over to the
> stone studio. This is sure better than using a block and tackle and crow
> bars, dragging stuff up from my basement storage back inToronto.
> I can't dig any trenches to put in power lines connecting the buildings
> until the frost is out of the ground. In the meantime, I can get everything
> ready between snowstorms.
> With a little luck and a flimsy extention cord, maybe one of these days, I
> won't need grid power.
> Cheers Warren
> Sent from Yahoo Mail on Android
> <https://overview.mail.yahoo.com/mobile/?.src=Android>
>
>
>
>