Re: Aw: Re: AW: Re: AW: Re: AW: Re: Re: Re: AW: Re: AW: Re: Re: [EVGRAY] Capacitive coupling of energy.

Body

With Tesla he was using positive pulse tec .each pluse pulled electrons out
of the earth and that's were the extra energy comes from . Bedini uses the
same system and with a ground you get 30% more energy .don Smith the same
he just uped the freq.to radio wave level and resonated the coils for max
transfer of the pos pulse but kept the stored energy on the big cap side .
there's a nother guy from Germany at a electrical engineering school doing
the same Tesla tec .he's theory is that the pos pulse when in transfering
to the second ball ...not needed ...runs into neutrinos coming from the sun
and gives them a charge  causing them to join into the energy collection
he's running a boat motor around a pool on micro Watts !! . and something
to do with the pope and shadow people .
On Dec 30, 2017 8:08 PM, "Mick [email protected] [EVGRAY]" <
[email protected]> wrote:

>
>
> Thanks Ole,
>
> Always excellent data.
>
> I misinterpreted the meaning of element.  Rather than shaded pole thought
> Hector was referring to an element as in copper rather than a part.
> Suppose the coil acted as a shorted part when Sven first hit the discharged
> cap still at super low impedance.
>
> Was not aware that a transformer would jump, doesn't this disprove the
> Newtonian physics claiming a reactionless drive is impossible, or is the
> transformer jumping in relation to the earth field?
>
> Do you know how the original Tesla induction motor with the rotor made of
> one type of metal functioned compared to the Steinmetz engineered models
> which GE made after they could not figure out the Tesla motors hysteresis
> functioned, in other words what was the big issue at the time?
>
>
> On 12/30/2017 11:31 AM, [email protected] [EVGRAY] wrote:
>
>
>
> Hi Mick,
>
> Try a shorted good conductor: https://wiki2.org/en/Shaded-pole_motor. It
> makes a mirrored copy of the magnetic field which cancels out the original
> magnetic field.
>
> Regards
> Ole
>
>
> ---In [email protected], <mkjekyll@...> <mkjekyll@...> wrote :
>
> So what is a good way to create said shadowing in an element or to prevent
> it?
>
> On 12/30/2017 9:53 AM, arkresearch@... [EVGRAY] wrote:
>
>
>
> Any magnetic shadow within an element will create motion during an
> inductive effect ..
>
> (H)
>
>
> ---In [email protected], <mkjekyll@...> <mkjekyll@...> wrote :
>
> Sven,
>
> I don't think you have components that would allow for higher impedance on
> the resonance coil.  I don't understand that claim concerning the high
> impedance other than if one looks at it from the standpoint of antenna
> engineering and RF.  Suppose what he is trying to say is the RV is
> translating EM to RF and during the translation is where the extra energy
> is harvested.    My own intuition says it is harvested on the vacuum side,
> the sucking side, as a part of the phase transform function or as you said
> when field collapses and is allowed to be useful rather than quenched or
> fought against.
>
> It is interesting many switching supplies use a HF flyback pulse to fill
> capacitors.  Hector said any of these supplies can run over unity with
> slight modification.
>
> It would be a good exercise to build the TV using vacuum tube electronics
> in the switching areas being damaged.  Tubes are high impedance but with a
> lower capacitance than FET's  they also do not allow for anything to block
> other primordial energies.
>
> I had a presentation from the 80's from the Tesla society and I forget the
> presenter.  Anyhow he took some old tube shortwaves into a mine or cave,
> somewhere underground along with solid state.  The tube equipment could
> hear the Russian woodpecker and some other things while the SS was just
> noise.  He claimed tubes could detect and amplify the scalar field.
>
> You did not answer why you think the transformer jumped sideways, due to
> what?
>
> On 12/30/2017 7:10 AM, 'Sven Friedrich' s.friedrich@... [EVGRAY] wrote:
>
>
> Hello Mick,
>
> that's all right, it works fine too. The resonance causes the saturation
> of the transformer and one hears it clearly how transformer works in
> resonance. Extraction is the problem.
> Hector always writes that you have to adjust the load, however he likes to
> do it. As I see it or understand it, there is a pros and cons for the
> resonance. I think that you can recharge your batteries so that they are
> permanently destroyed as he wrote it.
> The diode plug is the solution I think because we only work with capacitor
> charges.
>
> I always wonder when Hector writes that radiant energy is always or most
> effectively seen in high impedance.
>
> High impedance is for me the AC resistance in reactances.
>
> Does that mean for me on the transverter applied that the inductance
> should be as high as possible in the resonance coil?!?
>
> I can connect the windings so that I come well over 1000V but for the
> power is small and the capacity is small.
>
> In my Magnetic Voltage Constant, the inductance of the resonance coil is
> almost 1 Henry and the reactive voltage is well over 1000V. The resonant
> capacitors are connected in series to withstand the voltage.
>
> The problem with high voltages are always the components that have to
> endure, such as insulation, capacitors, switches, etc.
>
> regards
>
> Sven
>
> *Gesendet:* Freitag, 29. Dezember 2017 um 19:11 Uhr
> *Von:* "Mick mkjekyll@... [EVGRAY]" <[email protected]>
> <[email protected]>
> *An:* [email protected]
> *Betreff:* Re: AW: Re: AW: Re: AW: Re: Aw: Re: Re: AW: Re: AW: Re: Re:
> [EVGRAY] Capacitive coupling of energy.
>
>
>
>
> Sven,
>
> Why do you think the tranny jumped to the side?
>
> Was this magnetostriction or something else like lorentz force?
>
> A properly setup transverter is likely creating a  hyperbolic torsional
> field during collapse.
>
> When creating the self sustained self amplified spinning vortex coupling
> to the earth magnetic spin is when crazy shit can happen.
>
> Picture the similar spin of an RV's fields inside the transformer.
>
> On 12/29/2017 11:47 AM, s.friedrich@... [EVGRAY] wrote:
>
>
>
> So with adjustable impedance (Variac) in series from the powered Variac I
> could bring the BLDC in motion with the asynchronous motor and also reduce
> the power consumption to a minimum. The manual readings indicated a very
> low energy intake. The input power at the digital socket meter showed
> very high values. Very funny, I probably would not have fed any energy
> into the net. laughing.
>
> You can not do everything and experiment all around.
> One should already fixate on a topic in this big topic.
>
> So I praised the transverter, it's so nice and easy to bring it into
> resonance, the 50-60Hz technique allows you to use simple thyristors to
> discharge the diode plug capacitors.
>
> Sometimes I think it's the impulse that comes from the diode plug, which
> releases the free energy in the subsequent transformer first.
>
> The way I understood it all is the key. By bringing a transformer into
> saturation with a strong short energetic pulse and by collapsing the
> magnetic field, additional energy is drawn in from the environment into the
> collapsing field.
>
> This impulse has to hit the transformer like a hammer blow. I've already
> connected a 40 kg transformer with a SCR to a 5000 uF, the whole
> transformer has jumped to the side, unfortunately the SCR has not survived
> that, even though it should withstand more than 2500 A for μseconds.
>
> Of course, the impulse should be as small as possible so that just the
> saturation is reached, a stronger impulse would be just waste.
>
> Request for improvement of my understanding of the matter.
>
> regards
>
> Sven
>
>
>
>
>
>
>
>
> 
>