Re: Aw: Re: AW: Re: AW: Re: Re: [EVGRAY] Capacitive coupling of energy.

Body

Hi Mick,

Silver has less resistance than other conductors and when the surface of the wire is polished too there are less collisions of charges. This makes less noise when passing a current through such a wire. http://www.resistorguide.com/resistor-noise/ http://www.resistorguide.com/resistor-noise/. Using a superconducting wire would make even less noise as there are less collisions of charges making a more smooth current.

One problem in using idealized materials and components is that they are expensive. For consumer products this isn't the way to go. This is more for specialized products where the cost doesn't matter.

Regards
Ole

---In [email protected], <mkjekyll@...> wrote :

 Sven,
 Alibaba has some inexpensive BLDC controllers but none I have found seem to be phase adjustable.  
 
 Allegedly for the aether energies to work best non stranded single conductor oxygen free copper with a silver plating is considered optimal.  I have found this is similar in sound and with high end audio the smaller the wire the better and the silver plated sound is far superior.
 It would be interesting to wind the motor with this type wire.
 Following is the information on the Ronald Brandt BLDC motor with controller and windings:
 https://drive.google.com/drive/folders/0B7Fl9TsEYH5dMW9BX2QwMTAtNFE https://drive.google.com/drive/folders/0B7Fl9TsEYH5dMW9BX2QwMTAtNFE
 
 
 On 12/28/2017 10:11 AM, 'Sven Friedrich' s.friedrich@... mailto:s.friedrich@... [EVGRAY] wrote:
 
   Hi Warren,
 
 I stay tuned to the transverter and just because of it. You can not research everywhere that nobody can. I think there are a lot of approaches like the Daisychain or the Rotoverter Primemover plus Alternator.
 
 I personally have to be able to understand everything. This is still feasible for the transverter with 50 Hz and thyristors for me and I have the devices for it.
 
 What I personally would be interested in would be a BLDC controller to operate my Siemens permanent magnet motor without Hall sensors, since I have led out all the windings and since all the multifilar was wound I have 6 windings per phase. Hector once had a drawing with a Rotoverter Primemover the additional windings had to take over diodes in addition to energy. Something I would like to try with this synchronous motor. Unfortunately I can not find a cheap controller.
 
 regards
 
 Sven 

 ...